Kom godt i gang ES2
Tillykke med din Enkl Sound ES2
ES2 Quick Start Guide
1) Oplad din højttaler i 2 timer, hvis det er nødvendigt. Brug enhver 5V/1A eller PD-forsyning. ES2 kan ikke afspille maksimal lydstyrke under opladning.
2) Tryk på 'Power On/Off'-knappen i 3 sekunder for at tænde den.
3) BT-enhedsparring: ES2 tænder i BT std. parringstilstand. Alle de 9 LED'er vil lyse, når de er i parringstilstand. Find ES2 på din BT-enhed og par.
4) Juster lydstyrken på +/- knapperne.
5) For at konfigurere din ES2 til Stereo Mode, skal du bruge to stk ES2. På begge ES2'ere skal du dobbeltklikke på 'Power On' endnu en gang for at aktivere TWS-tilstand (LED'er 1 og 9 blinker skiftevis). De to ES2'er synkroniseres automatisk. Find ES2 på din BT-enhed (f.eks. telefon) og par.
6) Dobbeltklik på 'Power On'-knappen igen for at sætte ES2 tilbage i BT std. parringstilstand.
7) Tryk på knappen "Tænd/sluk" i 3 sekunder for at slukke.
ES2 opsætning til Stereo
Compliance
FCC
Warning:
To assure continued ompliance, any changes or modifications not expressly approved by the party.Responsible for compliance could void the user’s authority to operate this equipment.
FCC Statement:
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference, and
- This device must accept any interference received, including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement:
The device has been evaluated to meet general RF exposure requirement.
The device can be used in the portable exposure condition without restiction.
FCC ID: 2A8MI-ENKLES2